Jump to content
Mazdaworld
  • Announcements

    • Synesthesia

      Online source for ALL Mazda OEM parts.

      Original posted by "Anubis"   HAH! forget millenia. it has it for every mazda ever made. (well most )   here is the website:   http://www.trademotion.com/partlocator/ind...p;siteid=214264   enjoy guys.   *Administrative pin - Synesthesia
MazdaMomma

Question For Jdubs Or Someone Who Knows

Recommended Posts

http://cgi.ebay.com/2-BLAUPUNKT-12-VELOCIT...1QQcmdZViewItem

link to the subs Item # 270125363347

[url="http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=220120149492&ru=http%3A%2F%2Fsearch.ebay.com%3A80%2Fsearch%2Fsearch.dll%3Ffrom%3DR40%26_trksid%3Dm37%26satitle%3D220120149492%26category0%3D%26fvi%3D1"]http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=220120149492&ru=http%3A%2F%2Fsearch.ebay.com%3A80%2Fsearch%2Fsearch.dll%3Ffrom%3DR40%26_trksid%3Dm37%26satitle%3D220120149492%26category0%3D%26fvi%3D1
[/url]

link to the amplifier Item # 220120149492


What do y'all think? Will this work? Need feedback ASAP.

Thanks in advance.

Share this post


Link to post
Share on other sites
That should really be worked out with those power hungry subs. But having 400 W RMS to spare should be lots. Who is building the box for you?

Share this post


Link to post
Share on other sites
Make sure he gets the necessary measurements from Blau. So that the air movement is adequate... or they will be diminished.

Share this post


Link to post
Share on other sites
# sealed box volume: 0.5 - 1.0 cubic feet
# ported box volume: 0.75 - 1.5 cubic feet

Per Sub

Share this post


Link to post
Share on other sites
And get your money's worth.... whistling.gif

Share this post


Link to post
Share on other sites
Damn, i dropped the ball on this one. Box dimensions per the manufacturer shouldn't affect frequency response that much as long as the same box type is maintained. Basically if it's sealed you can deviate a little, maybe 30% before you notice the enclosure sounding a little weird. It will also depend on box type. Sealed boxes are normally pretty forgiving with deviation from specs, bandpass requires maybe 15% deviation, and a ported box requires very specific measurements to get the desired output. I would say within 5%.

Share this post


Link to post
Share on other sites
A great big thank you goes out to all the guys who helped Gotta get his amp and speakers up and running at the meet. notworthy.gif notworthy.gif notworthy.gif notworthy.gif

I cannot thank y'all enough.

The distribution block is in and the child is a happy camper. clap.gif

Share this post


Link to post
Share on other sites
He needs a cap asap to spare the alternator, his car was dropping below 12 volts on big bass notes. Once you start pulling 110% of an alternators rated output, it's a matter of time.

Share this post


Link to post
Share on other sites
As a bandaid, put a 1 Farad cap in line going to the sub amp. IF he's planning on two amps, get at least a 5 Farad supplying both. The battery looks good, he just needs to get the right supply power before he starts rowing through alternators. You can find the 5 farad caps on ebay or special order from Best Buy (last time i checked) for a couple hundred or less.

As an alternative, you might was to see if the local car audio shop sells Ohio Generator alternators or Stinger Alternators. They will be expensive, but they can be rewound to supply 14.x volts, but at a much higher amperage level.

Share this post


Link to post
Share on other sites
well, at 2400w peak, 1 farat is a bandaid, but 2 or more would be fine for the whole system in general. I think his amp dipped to 11.2 at the lowest, when it should be a constant 14.1

Share this post


Link to post
Share on other sites
I think I saw 10.9 once.... so yeah he is hitting the low levels...

Share this post


Link to post
Share on other sites
QUOTE(excluesiveonez @ Aug 1 2007, 07:50 AM) [snapback]175275[/snapback]

why would he gewt a stinger amp when it is a ohio gen. alt anyway (plus 100 bucks)

if hes going to spend 200 bucks on a 5 farad cap, dont waste the money and just go with the HO alt



Easier to get warranty swaps in person if it should fail.

Share this post


Link to post
Share on other sites
Yea, that should be good

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×