Open drivers door and leave open.
Lock and unlock the drivers door using the power door lock switch on the door.
Insert key into the ignition.
Turn key to on position and return to off position. (IMPORTANT - use ON position NOT ACC position)
Do this 3 times within 10 seconds. Leave key in the ignition
Open and close the drivers door 3 times. (Door should be left open after this step)
ECU should respond by locking and unlocking the doors.
Press any button on remote #1. ECU responds by locking and unlocking the car doors.
Press any button on remote #2 (etc.) Each time the ECU will respond by locking & unlocking the doors.
When you're done, remove the key from the ignition and the ECU will respond a final time with a series of door locks and unlocks.
Programming Remote Keyless Fobs
No replies to this topic
Posted 22 April 2006 - 12:07 PM
Mazdaworld Federation - Enforcer